H3C交换机基本配置

system-view

sysname Hostname

super passwrod 123456

telnet配置
user-interface vty 0 4
authentication-mode password
set authentication-mode password simple 222
user privilege level 3

[h3c]management-vlan 2 设置管理vlan
[h3c]local-user zhh
[h3c-zhh]service-tye telnet level 3
[h3c]telnet-server source-interface vlan-interface 2(为telnet服务端指定接口)
[h3c]telnet-server source-ip 192.168.1.1 (为telnet服务端指定ip)
[h3c]telnet source-interface vlan-interface 2 （为telnet客户端指定端口）
[h3c]telent source-ip 192.168.1.1

telnet server enble 打开telnet功能

local-user h3c 创建用户h3c
password simple h3c 密码为明文h3c
servber-type telnet 设置服务类型为telnet
lever 3 级别为3级（管理员）

========================================

vlan 1
ip address
port Ethernet 0/xx to Ethernet 0/xx

在VLAN接口10上选择全局地址池方式分配IP地址
[SwitchA-Vlan-interface10]dhcp select global
6. 创建全局地址池，并命名为”vlan10”
[SwitchA]dhcp server ip-pool vlan10
7. 配置vlan10地址池给用户分配的地址范围以及用户的网关,dns地址
[SwitchA-dhcp-vlan10]network 10.1.1.0 mask 255.255.255.0
[SwitchA-dhcp-vlan10]gateway-list 10.1.1.1
[SwitchA-dhcp-vlan10]dns-list 202.96.209.5 202.96.209.133
8. 禁止分配给用户的ip
[SwitchA]dhcp server forbidden-ip 10.1.1.1 10.1.1.23
[SwitchA]dhcp server forbidden-ip 10.1.1.200 10.1.1.250
[h3c]int vlan 3
[h3c-vlan-intterface]ip address dhcp-alloc

10.配置trunk：
[switch-interface3]port link-type trunk
[switch-interface3]port trunk permit vlan 2 4 6 to 10

11,路由配置
[h3c]ip route-static 0.0.0.0 0.0.0.0 192.168.1.1

[H3C] link-aggregation group 1 mode manual

将以太网端口GigabitEthernet1/0/1至GigabitEthernet1/0/3加入汇聚组1。

[H3C] interface GigabitEthernet 1/0/1
[H3C-GigabitEthernet1/0/1] port link-aggregation group 1
[H3C-GigabitEthernet1/0/1] interface GigabitEthernet 1/0/2
[H3C-GigabitEthernet1/0/2] port link-aggregation group 1
[H3C-GigabitEthernet1/0/2] interface GigabitEthernet 1/0/3
[H3C-GigabitEthernet1/0/3] port link-aggregation group 1

=============================================
(2) 采用静态LACP汇聚方式：

创建静态汇聚组1。

system-view
[H3C] link-aggregation group 1 mode static

将以太网端口GigabitEthernet1/0/1至GigabitEthernet1/0/3加入汇聚组1。

[H3C] interface GigabitEthernet 1/0/1
[H3C-GigabitEthernet1/0/1] port link-aggregation group 1
[H3C-GigabitEthernet1/0/1] interface GigabitEthernet 1/0/2
[H3C-GigabitEthernet1/0/2] port link-aggregation group 1
[H3C-GigabitEthernet1/0/2] interface GigabitEthernet 1/0/3
[H3C-GigabitEthernet1/0/3] port link-aggregation group 1

(3) 采用动态LACP汇聚方式：
# 开启以太网端口GigabitEthernet1/0/1至GigabitEthernet1/0/3的LACP协议。
system-view
[H3C] interface GigabitEthernet1/0/1
[H3C-GigabitEthernet1/0/1] lacp enable
[H3C-GigabitEthernet1/0/1] interface GigabitEthernet 1/0/2
[H3C-GigabitEthernet1/0/2] lacp enable
[H3C-GigabitEthernet1/0/2] interface GigabitEthernet 1/0/3
[H3C-GigabitEthernet1/0/3] lacp enable